At the centre of our isolation system is the S55 Elastomer Spring, developed in collaboration with leading European specialists in vibration control. Each spring is precision water jet cut to an exact specification, providing a compliant interface between the top board and the supporting structure. This reduces the transmission of vibration into the equipment, helping to preserve musical clarity.

The elastomer is selected for its load dependent deflection and vibration damping characteristics.

 

Acting as a spring, it supports the equipment while allowing controlled movement relative to the supporting structure. Its compliance does not come at the expense of definition or precision. When correctly loaded, it provides effective mechanical isolation at very low frequencies, with system configurations capable of extending below 12 Hz.

The material is designed to recover its shape following compression, maintaining consistent support over time.

 

As equipment weight and distribution vary, the number and position of the elastomer springs can be adjusted to suit the load. This is particularly important with amplifiers, where heavy transformers often create a substantial off-centre load.

Each configuration is therefore tailored to provide balanced support and effective isolation under actual operating conditions.

–

The result is a carefully matched isolation system for turntables, CD players and amplifiers, designed to reduce the mechanical interference that can obscure low level musical information.